NEWS
Services Available
CONTACT US
全國服務熱線
13789806976
- 聯系:李先生
- 手機:13789806976
- 郵箱:342711952@qq.com
- 網址:http://www.pxhecheng.com
- 廠址:山東省濟南市全福立交橋東100米路北(工業北路301號)通運汽配城3排15、16號 4排15、16號)
手動變速器齒輪油更換
來源:http://www.pxhecheng.com發布時間:2021-12-20 17:05:28
1.在新加注時要注意下列事項:;
1. Pay attention to the following matters during new filling:;
(1)旋出螺栓。
(1) Unscrew the bolts.
(2)齒輪油加注到加注口下邊緣。
(2) Fill the gear oil to the lower edge of the filler opening.
(3)旋入螺栓。;
(3) Screw in the bolts.;
(4)起動發動機,掛檔,并使變速器運行約 2min。
(4) Start the engine, shift into gear and run the transmission for about 2min.
(5)關閉發動機,并旋出螺栓。;
(5) Turn off the engine and screw out the bolts.;
(6)齒輪油重新加注到加注口下邊緣。
(6) Refill the gear oil to the lower edge of the filler opening.
;(7)旋入螺栓。;
; (7) Screw in the bolts.;
2.更換手動變速器油;
2. Replace the manual transmission oil;
操作一:將車平穩的停在舉升機上,并將車輛舉升到一定高 度o
Operation 1: park the vehicle on the lift smoothly and lift the vehicle to a certain height o
操作二:拆卸排放塞,排出變速器油液。qcwxjs.com
Operation 2: remove the drain plug and drain the transmission fluid. qcwxjs. com
操作三:油液排放完畢后,安裝排油口塞并擰緊。擰緊力矩 在60—80nm。
Operation 3: after the oil is drained, install the oil drain plug and tighten it. The tightening torque is 60-80nm.
操作四:通過加油口添加新變速器油,直至油位正好低于加 油口塞開口為止。
Operation 4: add new transmission oil through the filler until the oil level is just lower than the opening of the filler plug.
操作五:安裝加油口塞,并擰緊。擰緊力矩在25nm。
Operation 5: install the filler plug and tighten it. The tightening torque is 25 nm.
具體步驟
Specific steps
(1)操縱舉升機,將車輛舉升到輪胎最低點距離地面約20厘米的高度,并可靠鎖止提升臂,;
(1) Operate the lifting machine to lift the vehicle to a height of about 20cm from the lowest point of the tire to the ground, and reliably lock the lifting arm,;
(2)進入駕駛室,打開點火開關并起動發動機,保持發動機怠速運轉,如圖2-15所示。
(2) Enter the cab, turn on the ignition switch and start the engine, and keep the engine idling, as shown in Figure 2-15.
(3)操縱變速手柄,將變速器掛入1擋,保持車輛帶擋運行狀態。2—3分鐘后,將變速器掛入空擋,并關閉點火開關,停止發動機運轉;
(3) Operate the transmission handle, shift the transmission into gear 1 and keep the vehicle running in gear. After 2-3 minutes, shift the transmission into neutral, turn off the ignition switch and stop the engine;
我們一直在堅持分享的路上濟南奧迪汽車專修http://www.pxhecheng.com 真正為您解決您所需要的問題.
We have been sticking to the road of sharing, Jinan Audi special repair http://www.pxhecheng.com Truly solve the problems you need